Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi guys, would like to check out what's really the logging telling and what's the problem it will be. I have 2 unit of 6500 boxes with CSM. The topology is doing in single subnet mode. The server NIC is doing in SLB, where 1 primary 1 standby, and th...
hi, My WLAN topology is like this: one WLSE for centralized management, LDAP server for authentication purpose, plus aironet AP1310. I would like to ask either the AP1310 able to support the user authentication on LDAP server.If yes, can please sugge...
Hi Gilles, after a full inspection on the L2 config, found out there's no trunking allowed vlan on the FT and the VLAN server pass thru between the interconnecting switch...now 2 boxes in active-standby mode, and everything running smooth.Anyhow, i w...
Hi Gilles, yup, after look into sh mod csm X tech ft, i did spot the Virtual mac address: 0:1:64:f9:1a: available on both switch!! plus LRP Errors:Ver mismatch 0 Active State Collision 0 Standby state collision 0TX errors 0 xsum err 0 HB miss (0)kind...
Hi Gilles, Hmm, my network topology is 2 unit of 6500 boxes with CSM module with it.00:1f:9e mac-address couldn't spot it after i run the clear logging. But recently i do often saw this problem at the logging with this :"%CSM_SLB-4-TOPOLOGY: Module 1...
Hi Gilles, Hmm, my network topology is 2 unit of 6500 boxes with CSM module with it.00:1f:9e mac-address couldn't spot it after i run the clear logging. But recently i do often saw this problem at the logging with this :"%CSM_SLB-4-TOPOLOGY: Module 1...
