About dustin.coil

dustin.coil · 04-22-2009

Hi - I have a cisco c4948 switch using the 12.2(50)SG software. I am wondering how to set up the routing between two VLANs in the CLI. Thanks, Dustin

dustin.coil · 04-17-2009

I am trying to set up an activation server for a lab. The activation server is looking out to another server and getting its information that way. Therefore I need to connect over the internet. I want to use ICS on the activation server, so I have pu...

dustin.coil · 04-27-2009

I think I may have gotten a little farther... I can ping the destination server from the computer that is connected to the internet, and now I can ping the same server from the switch itself. I just need to find a way that all of the vlan's can also ...

dustin.coil · 04-27-2009

Ok, I may not be thinking of this correctly. For example I have two VLAN's with there own ip addresses (192.168.20.3 and 192.168.76.3), and all the other ports are assigned to use a gateway(192.168.124.1). I am still unable to ping from a computer on...

dustin.coil · 04-22-2009

Ok, then this must not be what I was looking for becuase I want to be able to ping from a computer on one vlan to another computer on a different vlan. Is this possible?

dustin.coil · 04-22-2009

Ok so when I'm in the CLI i start with switch# configure terminalswitch(config)# ip routingand from her i can hit enter or go into protocol -> purge -> interface and then hit enter.I don't see how to route two vlans.

dustin.coil · 04-20-2009

Do you mean move a computer off of the 4948 switch and put it onto the 2950?

Member Since	‎04-17-2009 08:59 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	7

User Statistics

User Activity

4948 Layer 3 Switch Routing

Connecting to an activation server through two switches

Re: 4948 Layer 3 Switch Routing

Re: 4948 Layer 3 Switch Routing

Re: 4948 Layer 3 Switch Routing

Re: 4948 Layer 3 Switch Routing

Re: Connecting to an activation server through two switches