Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello!I'm reading the doc at https://www.ciscolive.com/c/dam/r/ciscolive/emea/docs/2024/pdf/BRKSPG-2397.pdfNotably I'm interested in the partRP/0/RP0/CPU0:NCS#show controllers npu resources lem location 0/RP0/CPU0at the page 30.My question is, how to...
How can I aply something like PBR but for the traffic originated from the router interface itself in a multi-homed setup? See the diagram attached.I have 10.0.0.1/31 configured on TenGigE0/0/0/1. I would like ping replies to ping requests to that IP ...
Hello!I have a pretty standard XVLAN setup. In that setup server "A" with IP 10.0.0.100/24 can successfully reach server "B" with IP 10.0.0.200/24. Iperf3 performance if very good - line rate.My goal is to have additional IPs on those servers, serv...
If you are willing to limit ssh access to a router you need either apply ALC on the `line vty` if your router is running IOSXE (i.e. ISR) or under `control-plane -> management-plane` if your router is running IOSXR ( i.e. NCS).
