Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
which ios version and feature set is needed for vpn-client?in the docs it says anything >12.2.8T will do.but i can not see the command "crypto isakmp client configuration group 3000client"from http://www.cisco.com/warp/customer/471/ios-unity.htmli ha...
here is my problem.if i use the command...global (outside) 1 209.165.201.1-209.165.201.10 netmask 255.255.255.224 first 10 hosts are translated sequentially to .1 through .10, but the 11th host is not translated.!!unless i define an extra pat stateme...
Now,i want to nat by looking at the destination address.example if destination is network A then nat to x pool, and if destination is something different then nat to y pool.ios supports natting with acls and route-maps.but as stated in the command re...
Helloi can not get my vpnclient ping the lan...my vpn client is able to establish the vpn with pix ,an ip is assigned to the client from the lan range...when i try to ping the lan ,i see packets get to pix with debug icmp trace,i see the encrypt pack...
in your example, how is the dynamic map applied to the interface,with crypto map vpn-map interface outside...where as your dynamic map name is remote??
