Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Just getting wet around the ears on the Nexus line and have two small labs with a couple simple questions:Environment 1:1. Single N5K.2. Cisco UCS C-Series C220 M3 w/VIC1225.3. VNX SANAs a test, I would like to leverage the NIC virtualization technol...
That is correct. However, we should only be concerned with 120/1/9 & 130/1/9. The other blades haven't even been turned on. Here is the output:N5K-01# show interface trunk ---------------------------------------------------------------------------...
I have done the following:* ping 10.1.1.59 - only responds within the first minute or so after XenServer boots up. After that it doesn't respond.Output from N5K Peers:N5K-01# ping 10.1.1.59 source 192.168.72.2PING 10.1.1.59 (10.1.1.59) from 192.168....
Here are the two configs. Pretty simple and straight forward as I have yet to complete the setup.N5K01 show run!Command: show running-config!Time: Fri Dec 27 10:53:50 2013version 6.0(2)N2(1b)hostname N5K-01no feature telnetcfs eth distributefeature...
UPDATEI have made some progress but very little. Basically, I have blocked all physical ports that could possibly access this blade server except for those ports connecting directly to the dual FEX units. Just after XenServer finishes booting there...
