Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Any ideas as to how onside of the tunnel is not encrypting traffic thanks #pkts encaps: 0, #pkts encrypt: 0, #pkts digest: 0 #pkts decaps: 26731, #pkts decrypt: 26731,show crypto isakmp sa18 IKE Peer: Vendor Type : L2L Role ...
What could cause this message, shouldn't this part show the subnets I'm connecting via the tunnel. I'm guessing that it is anaccess-list issue"local Proxy Address 0.0.0.0, remote Proxy Address 0.0.0.0"I'm also gettng "Invalid ID info (18)"Thanks for...
Trying to setup a l2l vpn between 2 ASAs and came across this in the logThanksJun 21 17:07:46 [IKEv1]: Group = 71.172.68.18, IP = 71.172.68.18, IKE Remote Peer configured for crypto map: vpn_mapJun 21 17:07:46 [IKEv1 DEBUG]: Group = 71.172.68.18, IP ...
I'm guessing that the 2600 is no longer supported as the closest thing to it on the cisco web site is the 2610. Will the 2610 software run on a 2600. I need to get ssh running on it if possible. Thanks
Thanks for your help, we (the other side of the tunnel) seemed to have matched enough of the ISAKMP to create a whole new problem.I'll start a new post
These are the two configs, I'm not clear onhow crypto maps are linked to isakmp policy.Whats the best way to set both sides to thesame. I can see that both sides are using3des sha group 2. I get confused about policy 1 vs. 10 , 20 etcname 71.X.68.X A...
