Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear All, I am facing an issue with my 802.1x wired implementation. The authentication settings on endpoint is computers or users because ise allows domain users and domain computers network access. The issue is that when the user logs out of their p...
Hi All, I have configured wired dot1x between my switch and cisco ise and on the other hand ise is integrated with the windows AD for domain users and PC authentication. I have noticed an issue with some users. The issue is that they have IP phone an...
Hello All, I have implemented 802.1x wired in my network (EAP-PEAP) and the AD is integrated with the ISE server to allow authenticated domain users to access the network. The users are able to authenticate successfully with their domain username and...
Hello All, I have an issue after deploying wired 802.1x. The cisco ISE is integrated with windows AD, and the switch integrated with ISE as a radius server. The endpoint users logs in to their windows PC using their domain account and they successful...
I tried configuring device tracking on 2960X 15.2(2) E3 but the switch does not support this command. However, when I do IP device tracking interface, I can see the mac address of the IP Phone and vlan of the IP Phone and nothing related to the endpo...
By default the max-reauth-req is there which has a value of 2 on the ports.I already added the command but it can not be seen because 2 is a default value and I can see it when I do show dot1x interface.I will be able to see the command in the config...
Also one more thing, the authentication on the computer was user based, but still the endpoint was sending requests with the endpoint name even after the user logs out.
