Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My setup: 2106 controller with 4.2.205 firmware, 4x: ap1030 radio. We presently add 2x: Air-rm1252g-a-k9. My problem: I'm not able to activated the 40 mhz bonding channel on the Ap1252. I always receive the message: "Slot is not enabled or customised...
Hello!!1- already enabled2- already configured3- Not sure about this one: my "n" network is not enabled over the b/g band, only enabled in the 5.0ghz In thw wireless tab, under 802.11 b/g/n, high throughput (802.11n) the 11nmode is disabled.My proble...
Thank you very much for the Help, I'm now able to connect at "N" 300 mbps and make some fast data transfert... but after few meg exchanged over the connection...It fall back to "A" connection at 54 mbps. I'm normaly connect and hold 300 mbps at home ...
