Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is there a way to manually join a member switch? currently both switch are showing as master.show switch detail on master:Switch/Stack Mac Address : 0024.f9f7.4680H/W CurrentSwitch# Role Mac Address Priority Version State-----------------------------...
I have two 3750s and have connected the stack cable as sw1/port1 -> sw2/port2 and sw1/port2 -> sw2/port1. I started up the two switches and they were able to detect the presence of a stack. But strangely when I type 'show switch' both switch is showi...
this is how the cables are connected:switch1/port1 -> switch2/port2switch1/port2 -> switch2/port1and I noticed the switches have detected stack connection during boot up process. If the cables are not connected at all, the port status should be showi...
These are two new switches we just purchased and OS on these two switches are the same. When the second switch was booting there was a prompt for some initial setup for the stack which I don't remember exactly what that was. All I know is I tried to ...
