Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I would like to confirm an equipment config we will implement utilizing some specific Cisco equipment and a new high-speed WAN circuit. Currently we have a 20mbps and 6mpbs circuit coming into our environment (Ethernet handoffs) that we have front en...
Are you tring to configure your ASA 5520s in an Active/Active configuration? If so VPN functionality will be disabled. They must be set to Active/Passive.
The other 20mbps only kicks in when the 100mbps is offline...BGP. There is no load balancing or sharing with the 20mbps. The circuit being brought in is fiber. The provider is definitley policing the amount of traffic. This is not a burstable circui...
I agree, full duplex at 100mbps would make the 3825 too small. But the vendor will only give a CDR of 100mbps total...so if we send a 100gb file in each direction, we will only have 50mbps in each direction. With that being said...the 3825 shoud be...
I did just check the router config...it is using Fast/CEF switching...but I did see about 17 ACLs to block SNMP traffic and probably other are just anti-spoofing. So the next question is if I have ACLs is the CPU automatically reduced to the 20-25mb...
One last thing, since the spec sheets refer to not having any services enabled on the router to achieve those performance numbers, which we dont have any services running except for BGP...would BGP be considered a service and reduce the speed to the ...
