Hi @ROTTO84, Here are the commands we used.  I changed the .pem & .pfx file names to show where they get installed First part creates the config file for the requestSecond command uses that to create the key and cert, which is what the ASA needsThird...

Update: @Milos_Jovanovic solution works Following the guide Milos posted earlier with the changes below:In Azure you need to create an app for each tunnel groupUpload the 3rd party cert to each appInstall the 3rd party cert on the ASA  

@Milos_Jovanovic,Thank you for the clarification!  I'll give it a try and update the thread

Hi @Milos_Jovanovic, Thank you for the reply! Just so I understand correctly -  I have two VPN tunnel groups configured on the ASA - Tunnel-group1 & Tunnel-group2 In Azure, I create the AnyConnect app in Azure (following the guide you linked).  At st...

Hi @cusco, I know this is an old thread but I'm not finding any documentation that covers using a single cert for multiple tunnel groups so I was hoping you could post how you were able to configure the profiles in Azure to use a single cert from Azu...