Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a ASA 5550 running multiple contexts, but having the AAA authentication serial console (TACACS Server Name) LOCAL allows a tacacs challenge on connecting to the console but I am then unable to issue any commands i.e. enable or Show Run - messa...
After running the FSCK command on the FWSM Disk: I have orphaned files remaining but am now unable to delete them?On running the FSCK command it did ask for confirmation not to delete these files which was default, but as not knowing what this would ...
Under the System area on my FWSM module i run the sh disk: command. At the end I get error message "File Allocation Table might be corrupted, Recommend running fsck dsik:Has anyone run this command on a FWSM Module. can it be run during normal operat...
I have a Cisco 6500 running FWSM version 3.1(10)Have muliple contextsACL's are configured on 2 contexts to allow single hosts to communicate over TCP 7780 (HTTP)No Communication or Denys or Hits on ACL'sReseting the VLAN on source Context temp fixes ...
I have those setting applied with also :-aaa authorization command TACACS_Server LOCALaaa authorization exec authentication-serverMy TACACS account is OK not locked.On SSH connections it works perfect, but on console (serial) login it does not, TACA...
I understand the reason for this Static NAT proceedure from low to high security interfaces if Nat-Control is enabled, but it is not on my FWSM and it is still required? do you know the reason for that?Or is there a command to check to see if it is, ...
Any Idea's as to why a context stops passing traffic out? we seemed to have fixed the issue by building a new context with exactly the same config.Simon
A Capture on the outside interface (Source Context) shows a SYN being sent but nothing else. Also no hits on the ACL (Outside) so I do not think it is even getting to the Destination Context (inside)
Anu,Yes as 100% I can be the config are the same, we are also get no output in syslogs, no connections built. The statis nat on the source context is(outsdie,inside) x.x.79.x x.x.79.x 255.255.255.248 - so it is for the whole subnet - the incoming co...
