About yeewensmc

yeewensmc · 03-05-2012

Dear all, FYI10.1.18.71 (Firewall A)10.1.2.1 (Firewal B) (connected throughI've one Cisco 3750G-12S with ip routing enable, the swtich is with IP Service firmware, with PRR support.Currently set my default static route 0.0.0.0 0.0.0.0 10.1.18.71 to...

yeewensmc · 03-12-2012

Dear mr AnhThe trunk link is because the firewall B is located @ another location which is passing throught a switch. My switch is a 3750 12 fiber port switch. The interface 6 is the trunk link to my switch where my firewall B is located.Thanks & reg...

yeewensmc · 03-12-2012

Dear all,I've encounter some problem while setting the command below,interface vlan 2ip policy route-map route10traffic It prompt out CORE(config-if)#000252: *Aug 30 05:01:16.189 MYT: %PLATFORM_PBR-4-SDM_MISMATCH: PBR requires sdm template routingI'v...

yeewensmc · 03-11-2012

Dear Vivek,I've enter theset interface gigabitethernet 1/0/6 (interface trunk to my next firewall B)but when i key in theinterface gigabitethernet 1/0/6ip policy route-map route10traffic (don't have this command)I've enter the this insteadaccess-list...

Member Since	‎03-05-2012 07:30 PM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	5

User Statistics

User Activity

Policies based routing configuration

Re: Policies based routing configuration

Re: Policies based routing configuration

Re: Policies based routing configuration