Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HiI need to configure a backup circuit using IP SLA, routes with metrics, static nat rules for VPNS and so on, and that all makes perfect sense.I am however stuck on how I setup the dynamic NAT rules so that traffic from internal to Internet is natte...
HiI am working remotely on an AIM-CUE module running 3.1.1 and the request is to have a message waiting indicator light for user ext 554 when user ext 533 has a message. So effectively both users get the MWI when one user has a message.I have read t...
Hi,I have a voice translation rule:voice translation-rule 1 rule 1 /\(.*\)/ /xxx/ (where xxx is the ext that all incoming calls are going to)And this works fine. Question is, can I add another extension so that all incoming calls call 2 extensions?T...
A few days turned into 9 months but got there in the end. WAN failover (when using multiple NAT rules and VPN Tunnels) only works properly on ASA5512x and higher when using version 9.2(1) that supports event manager. configure a tracked route, SLA ...
Hi JouniThanks for your answer, I had come to a similar conclusion with the after-auto after reading another of your threads but as yet I have not tested it. I will do in the next few days and will then update you.Regards,Paul
I don't have access to this particular GUI so I can't say exactly for sure, but from reading posts from Rob Huffman it appears that it is possible:https://supportforums.cisco.com/thread/2154858
