About stephanejean

stephanejean · 11-16-2016

Hi, I have a Cisco 891F router with no service password-recovery set and it was loaded with a bad IOS. The router won't boot as the image is wrong and I cannot break to rommon because of no service password-recovery. Normally I would have been able...

stephanejean · 11-22-2016

I'm using a regular serial console cable. Rommon is not corrupt, the router was loaded with a wrong IOS. It was loaded with a IOS for 891 by mistake instead of 891F. When the router rebooted, it enter that boot loop because it cannot load the IOS. ...

stephanejean · 11-21-2016

What I've posted first is the entire boot process, one attempt only. It cannot boot the IOS loaded on the router, so it reboots every time. I can't seem to break that sequence and enter rommon because of the password recovery is disabled. Normally...

stephanejean · 11-21-2016

I can't make it boot from USB because I can't access rommon. The router doesn't seem to boot from USB automatically. I used a USB flash drive that I've formatted using another 891F and copied the IOS from that same router. I was however able to boo...

stephanejean · 11-18-2016

Thanks for your help, but I can't issue the break sequence after the IOS is loaded as the router is not able to load the IOS. I am surprised that Cisco didn't make a way out of this situation. That would mean a simple mistake or bad IOS and your rou...

stephanejean · 11-16-2016

I tried to boot while holding the reset button and it only shows this: Reset Button pressed. Changed to 9600 baud

Member Since	‎10-02-2015 05:05 AM
Date Last Visited	‎09-25-2018 06:58 AM
Posts	6

User Statistics

User Activity

Unable to recover IOS from rommon, no service password-recovery set

I'm using a regular serial

What I've posted first is the

I can't make it boot from

Thanks for your help, but I

I tried to boot while holding