Hello All,
I have a 2960-x switch that boots to switch:
I type in boot and it comes up fine.
How do I change the boot from manual to normal please?
If you show boot, Manual Boot is set to 'yes'. Want to boot by itself.
Sincerely,
R...
Hello Again,Richard Pasztor 34 posts since Sep 26, 2010Sep 7, 2011 1:41 PMCurrently Being Moderated12.2(58)SE2 on a 2960 cause memory leaksHi all,I had a very disappointed experience today during the planned upgrade on my 2960 to IOS version 12.2(58...
Have you done this on each switch, at this prompt done:# sh vlan brief (verify all ports are set to access, no trunks as no router)# sh run (verify your vlan # have unique addresses, same subnet mask and a default-gateway*)If this is basically t...
What switches are you using? I know with XL version (hardware) it will not allow Vlan 1 to work. Is this the lab found in Discovery 3 semester, chapter 3 by any chance? Little more info please. Finally, have done other vlans on these switches? ...