About ldewittleedy

ldewittleedy · 08-20-2012

I have just bought 4 Cisco Catalyst 4006 switches and i have been trying to configure them. It was passworded so i tryed to reset the config to take the passwords off. I tryed using documentation reguarding password reset but the confreg command didn...

ldewittleedy · 08-21-2012

It seems that all the moduals boot, havnt plugged anything in yet to test it but the status lights on all of them go from solid orange(redish) to blinking orange to solid green. but it only does a checksum of the Supervisor II Engine then skips right...

ldewittleedy · 08-20-2012

I think it could be the configuration because i tryed an extra Supervisor II Engine and its not POST'ing through moduals 2-6. Yet the 3 in the other switches will POST all of the moduals 1-6

ldewittleedy · 08-20-2012

Well i think it might be the configuration in the "Supervisor II Engine" Because i swapped out one of the moduals to test to see if the switch boards(moduals) were bad but it still didnt test the modual i knew worked. So then i replaced the Superviso...

ldewittleedy · 08-20-2012

Well im going through geting all the information i need on all the switches and i get down to the last one. (what im geting is the system info ie: show version+show mod+ everything it says when it boots up ie: post and modual checking) all the switch...

ldewittleedy · 08-20-2012

Hahaha wow, im feeling a little dumb. I guess i have to type "boot" to boot the system up .Ill keep you posted if i need anymore help Thanks so much.Lance DeWitt.

Member Since	‎08-20-2012 06:16 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	8

User Statistics

User Activity

Catalyst 4006 clear config /all

Catalyst 4006 clear config /all

Catalyst 4006 clear config /all

Catalyst 4006 clear config /all

Catalyst 4006 clear config /all

Re: Catalyst 4006 clear config /all