Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
So I have a mx105 to an MX 105 site to site vpn and all is working.My client vlan is routing all traffic across the tunnel.If my tunnel goes down I want the client vlan to route through the locally attached Internet connection.When the tunnel comes b...
o we just upgraded to a new 2gb enterprise fiber connection to the PORT 1 of our MX-105All is working fine and the performance is pretty darn good.My question is when connected with a windows client on lt2p VPN connection, I seem to be hitting some s...
MX-105 want port 1 SFP+ will not connectI have called support and their opnly suggestion is to buy a new GBICS.The GBICS I have work in all the meraki switches and lan SFP+ ports of ym mx-105I am at a loss here, and the purchase of a 750 to 1K gbics ...
We are looking into some devices on our meraki network.We have a solution or dev custom code to assign a specific device on the network to a sepcific work center location in our shop floor.Basically I want to use a cisco meraki API to kind the device...
something about this is now triggering some past issues with tis we had seen before. I will go look at that and see what comes up.I do remember thsi being a windows problem and not a Cisco problem for some reason.Time to break out some of the old sch...
Do other client VPN users have the same issue or is just this one? All are affected.Are you able to test with Secure Client? Do you mean anyconnect ? If so I dont have licenses yetDo you need to use full tunnel? Prefer to since we want full control o...
I gave you the Accept as solution, that documentation got me to exactly what I needed.Turned out the WAN1 was configured fir ethernet not SFP, changed it to sfp and set the uplink to auto and as soon as I plugged fiber in I got connectivity. Now Spe...
So after looking at this gain, I used a couple of the settings from the devices settings and I changed wan1 to SFP rather than auto then in upling I set 10gig-sr, plugged a crossover fiber into a test switch and boom was given the green light so to s...
