Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
1) have you issued the "no shut" command? 2) is there any router on other end of the ppp link? if there is no router, you will (afaik) never get any answer.3) in which state is your serial3/3? could you give us `sh int s3/3` ?4) are you getting any ...
Taken from:http://www.cisco.com/univercd/cc/td/doc/product/software/ios122/122cgcr/fipr_c/ipcprt1/1cfip.htm#1067360"The Cisco IOS software can provide logging messages about packets permitted or denied by a standard IP access list. That is, any packe...
If If you have one router on one side, and one router on other side, the you can make it this way:1) on both routers create an Loopback interface2) assign them /30 addresses3) on every interface (for ex. serial0 and serial1) put the `ip unnumbered lo...
