Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I'm using 2960G switch, when i connect FO single mode cable, it is not showing link LED though the other end is connected with device, could please advise what could be the problem?
Hi, Remote end is not an autoneg. Please confirm the following,1. Any configuration is required for Catalyst 2960G switch?2. Uplink port P/No.CN8ID42AAA is used in this switch, do i need to use any other uplink port?3.Is soft enable required for upli...
