About imranfbhatti

imranfbhatti · 11-02-2009

Hi all,I am facing Performance problems in our LAN.We have 6 Vlans , one of which is server vlan others are users Vlans.Problem is that when i ping from users Vlan to Servers Vlan i found high latency ( like 20 to 30 msec)We are using two catalyst 4...

imranfbhatti · 11-03-2009

"insure one L3 core switch is gateway for all VLANs."so how do we insure the redundancy in this case .secondly in this case HSRP is better than GLBP ? or one l3 switch for routing and same switch is the root bridge for all vlans ?

imranfbhatti · 11-03-2009

Dear vadadlaneyThank you very much for your supportattached below is the output of sh intport with shr status is down now but i think this is linksys wireless access point ( i am not sure)I have not seen any error on this port rather i observe some e...

imranfbhatti · 11-03-2009

Dear Joseph, In our case routing has been performed on the both 4506 switches.In case of 4506 how can we check unicast flooding?If unicast flooding exists , how to avoid this ?

imranfbhatti · 11-03-2009

Hi vdadlaney I d,nt think this is any oversubscription issue as i have not seen much traffic on the uplink/trunk ports. Attached is the spanning tree outt put from access layer switch.also sh platform health is attached as i think cpu process is not ...

imranfbhatti · 11-02-2009

Hi VdadlaneyThanks for your reply.Let me answer one by one1. we use 2 uplinks on each access layer switches, one connected to first core switch and second connected to second core switch2. Some time i noticed that there is transmit discards ( Output ...

Member Since	‎11-02-2009 03:32 AM
Date Last Visited	‎08-18-2017 03:54 AM
Posts	7

User Statistics

User Activity

Performance issue on LAN ( using GLBP and RSTP)

Re: Performance issue on LAN ( using GLBP and RSTP)

Re: Performance issue on LAN ( using GLBP and RSTP)

Re: Performance issue on LAN ( using GLBP and RSTP)

Re: Performance issue on LAN ( using GLBP and RSTP)

Re: Performance issue on LAN ( using GLBP and RSTP)