Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello!I'm using device C9800-40-K9 version 17.9.3. Two devices are connected directly back-to-back with HA port redundancy. I chose to run HA using the RMI+RP option, but last week, I encountered a strange error. That is, when the physical redundant ...
I'm currently using c9800-40-k9 version 17.9.3. I suspect this version is a bug, add the rmi port to the physical rp port. Therefore, when the physical rp port goes down, the rmi port also goes down at the same time.I'm not sure if updating the versi...
Thanks for the reply brotherMisconfiguration: Double-check the configuration of the HA setup, including the RMI and RP settings, to ensure that everything is configured correctly.The IP I set is as follows:Pri wlc :interfaceVlan1IP address 10.221.128...
