Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
Our peering network is build over SR EVPN using https://xrdocs.io/design/blogs/latest-peering-fabric-hld architecture, using Internet in a VRF and l2vpn evpn address family.After migrating first peering router (leaf) we started seeing in aggre...
Hello,
We are trying to upgrade from 7.5.2 to SPGISO0001, but fails with insufficient space error.
We have one unit which is not in production and USB booted to 7.5.2, then tried upgrade, with the same error.
Is there any fix to this?
Thanks
Below ...
Hello,
I'm trying to upgrade N540-ACC-SYS with AC power supplies from 7.3.2 to 7.5.2, but I encounter a major issue related to power supplies not being recognized.
I also tried to usb boot directly to 7.5.2 and the same thing happends.
rtr# show plat...
Hi, We are using a vrf called inet for all peerings ("Internet in a VRF").We have the following issue with BGP.When we issue the command show bgp vrf inet ipv4 unicast inconsistent-as we receive the following error:% Failed to retrieve data from EDM ...
Hello guys, Based on this awesome blog https://xrdocs.io/design/blogs/2018-05-09-metro-design-implementation-guide/ with a bit of redesign (also coming from Jiri's idea of non inline PE), would you agree with this topology? Purpose is to have all A-P...
Impressive basement.I think you can directly turbo boot it to 25.2.2 with usb.Be sure to have it on an UPS when you upgrade the FPD.upgrade hw-module fpd all location allIf FPD upgrade gets stuck or is incomplete when you inspect with admin show hw-m...
I also vouch for Cristian solution with single rd for same vrf.Look under router bgp address families (vpnv4/vpnv6/evpn) for these:router bgp 1
address-family vpnv4/vpnv6/evpn unicast
additional-paths receive
additional-paths send
additional-p...
@mahdihabashi
If you didn't try so far, I would configure ISE to allow command authorization for any command for this device.
Otherwise, if you have the configuration saved, the other possibility is to turboboot the device and put back the config.
I don't know exactly for this case, but generally IOS-XR has much more strict implementation of BGP then IOS, because IOS can run from ISR-861 to ASR-1009, but XR runs only on very big traffic boxes generally, so preventing human errors is a must (li...
