Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dears, I am facing an issue on Cisco 1815 series. I already configured 1 AP as master mobility express mode (IP 172.20.238.120). The show run config command is given below : (Cisco Controller) >show running-configNotice: "show running-config" has be...
Dear community,When configuring WLCs HA in SSO, is the AP base count permanent licence 퐢퐧퐡퐞퐫퐢퐭퐞퐝 from the primary WLC if the standby WLC is not an HA SKU (퐜퐚퐬퐞 퐟퐨퐫 3500 퐬퐞퐫퐢퐞퐬)? Is it required to purchase additional license for secondary WLC?Cisco's ...
Unfortunately, did not resolve the issue (Cisco Controller) >show auth-listAuthorize MIC APs against Auth-list or AAA ...... disabledAuthorize LSC APs against Auth-List ............. disabledAPs Allowed to JoinAP with Manufacturing Installed Certifi...
Kindly, please find below the show auth-list command on ME Controller (Cisco Controller) >(Cisco Controller) >show auth-listAuthorize MIC APs against Auth-list or AAA ...... disabledAuthorize LSC APs against Auth-List ............. disabledAPs Allowe...
Hi @Mark Elsen Thank you for your reply. There are no firewalling between AP and ME Controller. We are planning to deploy this solution a remote branch and we are simulating this on a switch C1000 (AP and ME AP plugged in same switch). Regarding N...
- There are no logs found from WLC when the AP tries to join. - The AP is pinging the Controller and vice-versa- The configuration report is given attached
For those with the same question, I managed to have the same ap-base count in both WLCs before configuring HA SSO. From GUI : Go to Management ==> Software Activation ==> LicensesIn case you have enough AP from Evaluation license, you can select add ...
