Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Got a bit of a weird problem trying to profile some Cisco 9120 APs on ISE 3.1Short version is that I have 3 APs connected onto a Catalyst 9300 with 802.1x enabled. 2 of them are successfully being profiled as Cisco APs by ISE (and thus hitting ...
Isn't that information sent from the switch? As I say the switch is successfully sending all of the device sensor information for the other devices attached to it, so I'm confident the AAA config is correct.
