Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I set up an IPSEC VPN tunnel between two pix firewalls 515 and 535 . I am able to ping between the hosts behind each pix firewall but i am not able to open or browse to any share . Workstation are windows xp. thanks for your help
i am trying to setup a new pix firwall (525). i named the inside and the outside interfaces and set the security level on them , but when i try to assign an ip address for the inside and the outside the command fails, has anyone experienced this iss...
the error i get is : pixname(config)# ip address outside A.B.C.C 255.255.255.0 ^ERROR: % Invalid input detected at '^' marker.the same error for inside or outside. Also when i try to type ip address ? there is no outside ...
