Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I've been having some in depth conversations with my colleagues at work and would like to peer into this forum for advise.Here is the setup/scenario: An AP with open auth. The AP is bridged to a layer 2 vlan on our core production switches. In thi...
Hey Folks,We are running two 4404 running 4.2.61 with approx 120 7920s. Some spots in the building MAY not have as much coverage as we like. (not many places).The phones are running 3.02 firmware.EAP-FAST auth against ACSv4.0Currently we have all da...
Hey Folks,Is there a way to change the backsplash and gui layout on a 7921? We would like to put our company logo and possible rearrange the icons on the screen.Is this feasible?Thanks!
I've been spinning my wheels for the past week trying to get this to work.My Goal: To have users switched back to their initial vlan after successful authentication/remediation.I was able to get this to work in the lab with a single vlan. I had a 1:...
Greeting Gilles, I'm runing into a brick wall here. I'm trying to configure redirection properly on our CSS11503's. The webservers are IIS and will be hosting multiple sites using a single IP. Each site will have its own port. IE: Site A uses port 10...
Did you get any resolution on this? I'm experiencing the same exact thing .... I mean to the T.
The only difference is my aps are set up for mesh. This wasn't an issue, I don't think, prior to me upgrading to 8.3 and upgrading my aps from 3502s to...
If everyone is going through a proxy this could explain what you are seeing. Remember, your sticky decision is being made by src IP. If everyone is using a proxy, then everyone is seen as the same src IP.Solution would be to bypass the proxy either...
So just to clarify ..... LB turned off globally, arpunicast enabled globally. Are you saying for the VoIP essid, disable "DHCP required" for the 7920's ?? Currently I have this enabled and I don't have issues with the phones trying to accquire IP a...