Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Trying to sort out an issue we've been plagued with since their installation. Using 9200 PoE to run Honeywell eQuip series cameras. Every week, random cameras will drop offline. They can't be pinged, anything. Disconnecting the cable or shut/no shut...
Recently set up 6 new 9200s. Configuration based off previous 2 9200 switches. I have been adding cameras all week, and finally came to a PTZ camera. While connected to the newly configured switches, when the PTZ is moved (set to 4mbps/30fps), these...
Setting up some new 9200 switches, and have hit a snag. I can reach the new switch, but cannot reach the connected devices. I have other switches working currently, and copied config line by line from them. From my new 9200, i can ping the connected ...
Fair enough, but after a shut/no shut on that port, we're back up. Welcome to my hell. EDGE3#config tEnter configuration commands, one per line. End with CNTL/Z.EDGE3(config)#int gi1/0/22EDGE3(config-if)#shutEDGE3(config-if)#no shutEDGE3(config-if)#e...
Here are the outputs. Looks as though the affected camera has power still, but no mac address when show mac add is run. Non working camera - EDGE3#sh run int gi1/0/22Building configuration...Current configuration : 146 bytes!interface GigabitEtherne...
ok, i see. Doesn't seem to be in the list. 1 default active Te1/1/2, Te1/1/3, Te1/1/4212 VLAN0212 active213 VLAN0213 active214 VLAN0214 active215 VLAN0215 active216 VLAN0216 active234 VLAN0234 active240 Surv-MGMT active
