Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone, I'm trying to use an MS120-8 to split 2 WAN links between 2 MX100s that are in HA. I followed this guide to set up the HA pair using downstream switches in a full mesh config for VRRP.However, I ran into real issues when I introduced the...
Thanks, everyone for your input. The consensus seems to be 2x unmanaged switch solution to avoid the awkward MS120 mgmt and remove the single point of failure. @byabczanka You might be onto something here - I think my MS120-8 had a statically assigne...
@Philip D'Ath To configure the switch initially I plugged it in downstream, let it download the config, then re-cabled without that downstream connection but with a public IP. After that, it remained orange, until I added that link back to create the...
@networksumo I've been referring to these two articles, which you may find useful: https://documentation.meraki.com/MX/Deployment_Guides/MX_Warm_Spare_-_High_Availability_Pairhttps://www.willette.works/mx-warm-spare/@Ryan Boyle When you have 2 ISPs (...
