Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all, As a network engineer working on a project to deploy and configure a series of ASA 5506-X running 9.9(2) iOS, I have encountered the following important issue:When I configure a NAT Exempt rule for traffic flowing from one zone to another ...
Hello all, I am trying to configure Port Mirroring on a Cisco SG300 using the switch Web Interface.I go to Administration>Diagnostics>Port and VLAN Mirroring.When I configure source and destination interface and click Apply I get the following error ...
Hello Abhijeet, I will try this to perform my tests, but if configuring directly through CLI is the only way to make NAT function properly, should I suppose it is an ASDM bug? Thanks
More precisely: When I configure the NAT rule all is ok at first.Then a few hours later the client calls and says that the VPN does not work as expected.When I check the configuration, the NAT rule is not there and I have to configure again. Seems li...
Hi,I don't get any error when I configure NAT.But the NAT entries disappear later on. The NAT exempt checkbox gets "unchecked" in ASDM and the NAT statement disappears.. Thanks
Thanks a lot. That will probably work, but I used the CLI to configure what I needed.Now port mirroring works fine and as expected. Thanks for replying. S
