Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have an issue with getting to the internet once authenticated via our Cisco ISE guest portal. Access to the internet does not work for at least 3 to 5 minutes before everything just kicks in and it works without any network intervention. We have C...
Hi Rich After going through all the config again today I found that COA was disabled on the ISE Radius setup used for the guest wifi. Enabling this and implementing various other WLC best practices made a massive difference. Thank you everyone for...
I will look to do this first. As it may resolve a fair few issues, although knowing my luck introduce new ones as well. We initially setup on the latest version going back a few months back but the firmware version was not compatible with our acce...
Hi I cannot see a load balancing option under the server group. I do have two separate Radius configurations. 1 is for our parent company consisting of 2 ISE nodes. The other is a single ISE node which we have setup for our Guest wireless so we ca...
So the guest wifi takes account registrations via a Cisco ISE portal. The user account is created and then approval for the account is requested and approved via the Cisco ISE Sponsor portal. However the accounts are local to the controller and no...
So once the credentials are entered and the clicks log on. nothing happens, for a good four or 5 minutes and then it springs to life and starts working.
