Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, On Switch we can check the SFPs Model/Serial number by the well know commands like "show inventory" or also we can get some details about SFPs with the help of command "show interface status" and there are multiple help article on internet th...
Hi,
When you configure manual priority as given.
spanning-tree vlan 1,10-15,99-100 priority 4096
and on downlink Trunk Link you configures "spanning-tree guard root"
Then if connected switch sends BPDUs and we did not included the vlan 16 on ...
Hello,I have attached a topology for you to understand the HSRP process. I hope this will help you. Note : Always use cross cable to connect same device other wise your CPT topology will not work. Thanks Deepak Kumar