Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Experts,In datasheet, RSP 720-3CXL can support 1,000,000 (IPv4); 500,000 (IPv6) routes.Is this based on the default RAM config?- Route processor DRAM 2G (Default)- Switch processor DRAM 1G (Default)when do we need to upgrade RSP720-3CXL processor ...
Hi all,I have a PIX 501 running ver6.3(4).I have disabled PDM and HTTP server with following commands, and removed all pdm and http server statements.pixfirewall(config)# no pdm history enablepixfirewall(config)# no http serverI have no web servers i...
I can't seem to find why port 80 and 21 on my PIX 501's external interface is opened. But not on 515e with almost similar configuration.I can telnet FW-EXTERNAL-IP port 80 and 21.PIX Version 6.3(4)interface ethernet0 autointerface ethernet1 100fullna...
HI Laaubert,Thanks for quick reply.Under Cisco Configuration Tool, there is an option to upgrade SP RAM to 2GB.(Part number MEM-RSP720-SP2G)(Description C7600 RSP720 SP 2G Memory)Can I confirm that the datasheet describing RSP 720-3CXL able to suppor...
Hi Patrick, Below is my full config, I have no servers on this remote site so the only NAT is a PAT to a global addr.PIX Version 6.3(4)interface ethernet0 autointerface ethernet1 100fullnameif ethernet0 outside security0nameif ethernet1 inside se...
Hi M.sir, Thanks for your quick reply, unfortunately you misunderstood my question/issue. My firewall's public IP address on the outside interface has port 80 opened. I can run the following command to see that port 80 is opened.telnet 123.23...
