Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Sir/Madam,I have a problem that the built-in ACL in the Controller 4136 does not work on dynamic interface. I can't apply a ACL to block PING to the dynamic IP address successfully. However, I can use the ACL to block other IP addresses which ar...
I want to upgrade the existing Layer 2 contollers 4100 and AP 1200 (in the same subnet) to Layer 3 (controller is different subnet from AP). Due to migration in phases, I need to have mix Layer 2 and Layer 3 controllers in short period of time. Any i...
Thank for information.My case is a pure layer 2 VLAN which is no default gateway or router. The Cisco Controller release note mentioned not support PING to dynamic interface, however, I can continuously ping it from Radio side.
On the controller page, General, there is a option LWAPP Transparent Mode to select Layer2 or Layer 3 mode of the controller. Not sure why can't convert from L2 to L3.Actually I had converted few L2 controllers to L3 in the same mobility group in lab...
