Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi AllI am trying to install CML 2.8 on a HP Proliant DL380 G6 and get an error during the 'running early commands' just after the 'running chvt 1'.The response is 'An error occurred. Press enter to start a shell'.Regards in advanceJohn
HiI have an issue with the following environment: Cisco Modeling Labs-20240528T17470631It is showing a 'Termination Failed'. Please could a 'Force Ended' be carried out on said environment.Regards in advance.
I have now been waiting for the Cisco Modeling Labs to terminate for the last 5 days without success.The URL for the Sandbox is: https:devnetsandbox.cisco.com/DevNet/sandboxes/Vqq9c677hBo3/simplifiedAssistance would be most helpful in resolving this ...
Hi @bigevilbeard I do hope this is what your are requiring?This is the thread of the Sandbox: https:devnetsandbox.cisco.com/DevNet/sandboxes/Vqq9c677hBo3/simplifiedRegards in advance.
I also have the same issue. So I thought that purchasing the CML Licence would give me access to the environments. Though I was not aware that you have to have hardware for the CML software to run on.What a waste of money.
