Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
How to create SSH for Catalyst 1200-8FP-2G Smart Switch device type, I have problems when SSHing from device 1 to another device, or from the Fortigate device to the switch device, but if I SSH from a laptop there is no issue
I have a complex network that is already running, there is a condition where I need an additional IP address because the IP address is almost full, is the best solution to create a secondary IP address on the same interface or do I change the subnet?...
Currently we are having problems with Meraki's new policy where every wifi password has a minimum requirement of 12 characters etc.but we found a bug where the generated password cannot be used until we enter the password using copy and paste.is it p...
hello, do you have idea or advice for How to generate automatic guest passwords per day?or is it possible to implement using vouchers on the SSID Guest per day?thanks
but I have a Catalys 9300 series that can run failover without LACP, is there a separate configuration in the 9300 type that is not supported in the 1200 type? I see there is a configuration, redundancy, sso mode. Is it necessary to use a specific ST...
indirectly does this c1200 switch support failover to forti HA with the configuration on the interface only using switchport trunk mode? or forti and the switch must be configured with lacp on each interface? thank you very much for your help
Okee, last question, I just want to make sure, is it possible to only use switchport trunk mode to the fortigate HA device, but if interface 1 is down it can still run towards the fortigate backup? because my problem is that I can't run towards the b...
I don't mind, I just need to convince my boss that later the device can be remoted from afar, I can ssh because the LAN cable is directly to the switch device, but I can still remote to another switch from the device I direct, but I can't from fortig...
if on another type of device doing ssh from a different switch device there is no issue, does that mean that the cisco type 1200 does not support ssh from a switch device with the same type? and if I try ssh via fortigate which goes directly to the s...
