Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, I am using a Cisco 2801 Router and currently have Telnet enabled on all interfaces. How do I change that so it is enabled from all inside networks, but not on the outside interface? Thanks!Here's what I can find in the configs regarding Teln...
I just installed a new ASA 5505 for an office with three internal subnets. The three networks can each get online fine and ping eachother, but cannot browse to shares on the two internal networks other than their own. How do I configure the ASA to ...
I have a VPN client connected to a Cisco 2800 series router as the concentrator. The client successfully connects, but can only communicate with one network on the host side. The VPN client is assigned an IP on the 172.16.2.0 network, and it can on...
I do not want telnet allowed to the outside interface at all, but we do have email services, etc. allowed through NAT commands. Would I need to permit those in this new "no_telnet" access list, or will those still be allowed with the existing config...
Manish, thanks again. I applied the configs as instructed (below), but can still telnet to the public IP from outside the network. Is there a command that is allowing telnet to the outside interface that supercedes these configs? ip access-list ex...
