Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Community,We are migrating from old wlc 2504 and old access points 3702e to the new 9800 wlc and new 9136I access points. The configuration on the new wlc has been migrated from the old wlc, and we will connect the new WLC 9800 while the old WLC...
Hello All,We are in the process of migrating from old cisco ap's and wlc's to new wlc's 9800-L and ap's 9136I. The dhcp server for all the vlans, ssid's etc are located in the core switch.Now, the issue is that when the AP's and WLC's are in the same...
Thanks for both solutions. Just before I mark on as a solution I want to clarify something about the HA in access points. So in the 2504 old WLC, in the wireless > access points > high availability, if I keep primary controller as the WLC 2504 (OLD)....
It will be difficult because there are 40 ap's and are in different sites.Umm but if I can push any configuration from the current 2504 WLC, that seems to be easier and also I checked the HA for the current APs in 2504 WLC and I can see the IP of 250...
Yes, the configuration is same.The only difference is that the current WLC is vlan 100, and the old ap's are in vlan 200.The new WLC and AP's will be in vlan 200 (this is the requirement).Please advise.
