Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have 6 Hub-sites where we currently have a flat network with PIX 525, Catalyst 6513(Backbone local switch) and a Cisco 3660 (WAN router) connected to the same subnet. All the routing is performed by 3600 at this point. We are installing two Sup720 ...
I have a DMZ (off the DMZ-port of the PIX 525 firewall) with the customer routers sitting there. We are using dynamic NAT and static routes on the PIX-firewall. The application we run is FTP - out to the customer servers. The PIX has static ip route ...
Thank you for the answer. Do you recommend to move this link (6513-3600) to a separate subnet as both 6513 and 3600 are on the same flat primary subnet as the servers and workstations today. If yes, what are the advantages of this solution?
Thank you for your answer Mike. I still have a question:1. If I have more than one customer - should I still use a single router and ACL's to keep the traffic from the different users separate?2. Which routing protocol should I run between the custom...
