Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello George...first thing I noticed is that you don't have a translation rule for you internal users to reach the DMZ. maybestatic (INTERNAL,DMZ) 192.168.20.0 192.168.20.0 netmask 255.255.255.0I don't see a reason why you would translate your inside...
Hello avvenk,FYIThe FO and FO_AA licenses are intended to be used solely for units in a failover configuration and not for units in standalone mode. If a failover unit with one of these licenses is used in standalone mode, the unit will reboot at lea...
I don't think it'll work since your commands are attached to an interface, not to a name. Try this if you have static commands,static (inside,outside) 1.1.1.1 2.2.2.2 netmask 255.255.255.255If you change the name of the outside interface to test, you...
Hello Binoy,looking at your config, your internal lan has public ip addresses, but for some reason you PAT'ing them to the outside. So the best way to allow a host in to your network is to create static translations for the ports and protocols desire...
