Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,I have a Cisco 2960, Version 12.2(25)SEE.Each interface is in trunk mode: a ip-phone (alcatel) and a PC are connected to each interface. And DATA and VOICE are in two different VLAN.It works fine.However, I notice today that when I sniff, with...
Hi all,I need to upgrade my PIX 525 from current version 7.0(4) to a more recent one: 7.2(2).I have a doubt because the new code is larger than the current one. And I have not enough space in memory to put both codes at the same time. So I think the ...
Hi,Is it possible to configure two default routes with the same metric on a cisco switch 3750?In fact, I would like to make load balancing between 2 firewalls with these two routes.Thanks you by advance for your help!
Hi all,I would like to use 2 ASA and set up an active/active failover configuration (with 2 differents ISP).I found that documentation:http://www.cisco.com/en/US/products/ps6120/products_configuration_guide_chapter09186a008045247e.htmlAnd I wonder if...
Hi all,I have few Cisco Catalyst 3500XL (12.0(5.2)XU) and Cisco Catalyst 2950 (12.1(9)EA1) and I want to get for all interfaces the "ifLastChange" object:"The value of sysUpTime at the time the interface enteredits current operational state. If the c...
Hi Yandy,The trunk port isn't a transit interfaces between the two hosts communicating. And these two hosts are not connected to this switch...For an unknown reason, this traffic arrives however to the uplink of the switch. And these trafic is then f...
Hi,Thanks you for your quickness!However, you misunderstood me... here is my problem:Suppose I have a host, let's say 192.168.10.10 in DATA VLAN. this host is connected to an IP-Phone, let's say 192.168.5.10. This IP-phone is connected to a port of m...
Hi,1) correct2) If 74.41.202.106 is the ADSL router address, you should set the "outside" interface to an address in the same subnet of your ADSL Router. And your default gateway on your PIX will be the ADSL Router.Hope it helps
