About earthgazer

earthgazer · 12-09-2008

Hi,In a recent power loss (took out our R&D UPS in the process), an MDS 9216 we have in R&D failed.On power up, it shows a red status LED, and does nothing. We've pulled and swapped PSUs (something we're told is a common fix for a common problem with...

earthgazer · 12-15-2008

I suspected as much warranty-wise.Slot2 was already empty, so I can only assume that it's the PSU's, or something seriously wrong with the backplane.In an energetic mood, I did pull and reseat both slot1 and the management card, without any luck what...

earthgazer · 12-10-2008

Is this covered by warranty? I can't recall what it is for this unit...I'm aware that the slot 1 card is "not replaceable", but reality is that the card is screwed in (rather than captive thumb screws) and the screw holes are just covered by the faci...

earthgazer · 12-10-2008

Hi,It doesn't even get that far - so I don't suspect it's an issue with the line card.Given the unit is a number of years old, I don't think it's under a support agreement - so other than an RMA, what is the likely solution? New PSUs, chassis?Thanks...

Member Since	‎05-23-2006 02:23 PM
Date Last Visited	‎08-18-2017 03:55 AM
Posts	4

User Statistics

User Activity

MDS 9216 - showing red status LED, not starting up

Re: MDS 9216 - showing red status LED, not starting up

Re: MDS 9216 - showing red status LED, not starting up

Re: MDS 9216 - showing red status LED, not starting up