Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Is it possible to integrate CW LMS 2.5/2.6 and HP OpenView NNM 7.51. As I know CiscoWorks Integration utility supports NNM 7.01 only.Thanks for answer!
Hi, collefues!I have the question abou the status of DFM alerts and events. Some alerts stays permanent in active state because of some events (included in alerts) has the active state. But the events should be the cleared already - the causes of the...
I have the following abnormal bahaviour of RME (LMS 2.5.1). After discovering and adding devices to DCR, I defined telnet community for each device (I add the user "cwuser" at the ACS and each device use ACS primary authentication). When I try to...
Hi, collegues.I have the following problem after integrating LMS 2.5.1 with ACS. All the devices on the topology map of CAmpus manager are red and marked "unreachable". The problem solves after changing from ACS-module to local-auth module and then a...
Ok, Thanks a lot, Martin!I tried to do it with the latest NNM atapter (version 2.1, 2005 year!). I didn't see the CiscoWorks group of alarms in Alarm Viewer of NNM 7.51!As I understand, Cisco does not hold up to date the integration tool. Don't HP pr...
It is possible. CM periodically polling the devices that it knows (minor acquisition) - 1 hour by default. And every 4 hours (default) polls the network and attempts to discover new devices. It is possible to poll quicker, but it is ineffective. ...
Campus Manager doesn't react immediatly while the status of your devices changes. CM polls devices periodically (every hour or every some hours). And if it detects that device unreachable during the polling, it will be green. CM is not the tool for r...
It is the correct behaviour for this configuration. Cat6500 uses MSFC only for the first packet, and the last packets are switched using PFC (CEF, dCEF). To correct configure Netflow export on the Cat6500, you must enable Netflow on the MSFC and on t...
Thanks for reply!Acknowlegement... As I understand, acknowlegement doesn't remove the alert and it will be present in alert page forewer, acknowleged, isn't it?What type of event? I saw different types. For example, just niw I have "duplicated IP eve...
