Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Is it possible that CSM has two client side vlans? The reason why i need to configure 2 client-side vlans is the ip address of the first client-side vlan is running out.Thanks.J.W.
Hi,The network topology is :user's pc---Cisco3600---CSM-S---FWSM---ServerUser needs to access server's real IP. How to configure the CSM-S? I tried the configuration below but failed to ping the server from user's pc.I configured a static route on se...
Hi all,I couldn't find any command to check the GSS is making use of NTP to get the correct time from NTP server. Can anyone please advise how i can check. Thanks.Jianwen
Hi, Does the following messages show that it's working? Thanks.#tcpdump interface any protocol any host tcpdump: WARNING: Promiscuous mode not supported on the "any" devicetcpdump: listening on any17:41:46.160704 x.x.x.x.ntp > y.y.y.y.ntp: v4 client...
Thanks Gilles.Have you tried to shutdown the interface(inside or outside) of CSS?During my test, the failover works if i reboot the active CSS. However, it failed when i shutdown one of CSS's interface or pull out the cable. If you can test this scen...
