Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
'boot' command isn't available at the 'switch#' prompt.'switch(config)#' prompt allows the boot command to be used so I tried that but then can't get the copy command to work.Any help greatly appreciated.
I've looked at this again. I think the issue is with the 'install all' command, it gets as far as the 'images will be upgraded according to the following table', it shows then table and then just drops to the 'switch#' prompt, I don't get asked 'Do y...
I know I'm resurrecting an old thread but hopefully someone is still around to answer my question.I have a Nexus 6000 and I did a factory reset on it, this deleted all the files/firmware so I used the video from this thread in an attempt to get the m...
