Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Good morning.....We recently upgraded our controllers from 4.2.185 to 6.0.188 and have noticed many clients having connectivity issues. We have Aggressive load balancing turned off globally but have noticed that band select and load balancing are ena...
We are deploying an a/b/g network using 1242,sWe plan on using directional antennas to cover about 150feet. There are some obstructions betweenthe ap's and client coverage area. Any antenna recommendations would be much appreciated.Thanx
Hi,We are using the anchor mobility feature to authenticate 802.1x/WPA2 clients. We see that dhcp/data traffic traverses the Eth/IP tunnel, but do not see the authentication/radius packets. We see the authentication sourcing from the local controlle...
Hi everybody, Has anybody had problems authenticating Mac PEAP clients ? We have sniffed the exchange over the air and see that the WiSm sends an access accept message to the client, but the subsequent EAPOL key exchange fails. We are using the "Radi...
Good afternoon. If you are using a wism blade in a 6500 chassis you can still disable the port channel and have access to the wism. This could be done by using the session slot x processor 1/2 command on the 6500 cli
Hi Tony,If you want to go with something thats cheap and works quite well you could look at a wireless sniffing package called "Kismet"You can use Kismet to capture over the air and then use Ethereal(Wireshark) to look at the packets. ...
