Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi!We are a small science institut having like 35-40 Cisco access points that are connected to the near-by University and their Cisco Wireless Controller (9800-40-A?). However, some of those APs do loose their connection to the WLC or cannot find the...
FYI, it seems that we solved our issue with the APs not being able to join the controller.Not really sure what did the trick but we saw some "Single:No_Traffic" states in pfsense Firewall. This leads to the assumption that NAT is not correctly workin...
Can't really tell, but one of the controller has a firmware on that supports the 9176 APs, the other has an older version that gets rejected by the APs then.
Hi Rich!Well, 2 of the 4 IPs are not valid and are actively blocked in our firewall. According to the admin of the controller, these are IPs for another site location of theirs and not reachable from out network, but he can't get some configured out ...
From within the network nmap -sU -p 5246-5248 to the controller shows:PORT STATE SERVICE5246/udp open|filtered capwap-control5247/udp open|filtered capwap-data5248/udp open|filtered caacws
There is enough space in the pool. We have like 40 APs and the pool is configured to use the whole /24...VLAN 30 was created after VLAN 300, but then again: out of 38 APs in that VLAN 30, as of now 29 APs are actually working. 9 APs do not.
