If I have a firewall with no code on it and boot it into rommon mode, can I pull a code off a USB drive, or can I only do it by setting up TFTP parameters and then copying it down from TFTP server? thank you

Is there a way to set the order of preference you want a remote access client to authenticate to radius servers? We have 2 Radius servers currently configured, need to add 2 more that will take the place of the first two. But I don't want to remove t...

Is the output of the "show nat" command, which shows the number of thits on NAT rules, a reliable counter in the same way that access-list counters are, meaning unless cleared or if the firewall is rebooted, can I count on these hit counts as being a...

It is my understanding that you can configure up to 4 DHCP servers on an ASA. So if an ASA was configured this way, (with 4 relays configured on the same interface) does the firewall go through the list of the 4 relays in the config in order? If the ...

I've got an old PIX running 6.3 code. Finally upgrading to an ASA 5515 running 9.2 code. I can't keep up with all the NAT changes that have taken place through the years. I have several of basically no nat statements on the PIX, like below: static (i...