Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I want to have open wireless access for Clients that visit seperate from our network. I setup DHCP on interface 0/2 and though everything appears to be configured right it just isn't receiving or responding to DCHP requests. If I monitor DHCP st...
Didn't work. I have blown away this configuration and recreated at least 7 times with different names. I even tried making a new vlan interface from 0/2. Finally I had to resort to asking for help. Cisco Adaptive Security Appliance Software Versi...
Well it took a while but I think i got it going. Show dchp-cap doesn't work for me, but please understand that I barely know how to work this equipment unfortunately, but I'm learning. I had to look up how to get in and out of config mode. :$ Th...
I ran the following to commands and received "enabled at level 1". I then had the dhcp client searching for a server and ran the commands several times during this period with the same results.CDG515ASA01# debug dhcpd packetdebug dhcpd packet enable...
Actually it was because the laptop was in sleep mode. I woke it up and the lines went UP. Yes I can ping 10.0.27.15 if I statically assign an IP.Yes I have tried other machines other than this laptop.Interface Ethernet0/2 "OpenInternet", is up, line...
