Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have situation wher all the traffic to the DMZ is PATd and now works as long as users are on Inside lan. Now we want have users connectiong to RA VPN which Terminates on the Same firewall outside interface access the DMZ.At present we have ...
Hello,We have L2L VPN between Cisco router and PIX515E. We recently added couple of hosts to Encryption domain and when we try intiate traffic we get Send Errors on sh ipsec sa. The hosts that were there proviosely in Encryption domain are accessib...
Hi,I tried NAT on Inside Interface and did not help. We dont have nat-control enabled and dont think NAT 0 makes much differece on the DMZ interface. Also, the traffic is intiated from the VPN Client range and not from the DMZ.Regards,Venky
Hi Federico,Thanks! for the response.But, if I do NAT 0, VPN Clients IP 11.11.11.x doesnot get PATd to 10.10.10.10. I want to achive NAT for all the Traffic from RA VPN CLient to Global (DMZ1) 100 10.10.10.10Regards,Venky
I have pix 515E with 6.3(5) running and i dont think i have option to run packet tracer. I do not have any VPN filter applied. connection always intiated from PIX not from the other end.
